Home/Support/Support Forum/How connect a LCD display with VGA connector and touch screen 4 wires.‏
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How connect a LCD display with VGA connector and touch screen 4 wires.‏

0 votes
Hello,
I'm working with a Wi-iMX53 and I connected a display with VGA connector and works. This display has a 4 wired touch screen and I want to cennect It but Idont know how. I was reading a lot and I read that the Wi-iMX53 has a DA9053 that is connect with a parallel LCD. I thinking in connect my touch screen to those DA9053 pins, but I dont know if that is dangerous or what. Can you helpme?
Thanks.
asked Jan 19, 2016 in Linux by emmanuel_perea New to the Community (38 points)

Please log in or register to answer this question.

1 Answer

0 votes
you have to figure out what interface your touchscreen is using (SPI? I2C?) and then connect it to the appropriate interface on the board, matching the pins and signals.
answered Jan 21, 2016 by LeonidM Veteran of the Digi Community (3,936 points)
Hi, thanks for response.
 I just have a touch screen sensor without controller with 4 wires (+x, -x, +y, -y) and I want to use the pmic controller of the Wi-iMX53 connectcore, and my question is where or how I connect It or if is possible connect It directly . The parallel LCD connector is connected to +x, -x, +y and -y pins of the pmic controller. My monitor is VGA. Is it possible connect It directly to those pins?
commented Jan 22, 2016 by emmanuel_perea New to the Community (38 points)
yes, looks like it should work
commented Jan 22, 2016 by LeonidM Veteran of the Digi Community (3,936 points)
...