Hi to you all this is my first time on the forum so please take it easy on me if this is simple. Okay so I have 3 xbee's
XBP9B-DMSTB002 rev E I am trying to connect to them in X-CTU and am having no luck.
I have tried all baud rates, resetting them through pin 5-10 connection, tried different parities etc etc any settings I can think of including the programmable ones.When I looked up the serial number I found they were programmable ( I believe this to be true)
I have tried a several new usb cables into my xbee breakout board. I then suspected the breakout board (all three of the xbee's are giving me no joy and they can't all be bad?) I have used an ftdi cable to serial dout and din and passed powe rot he unit from an arduino delivering 3.3v (approx). When I minicom into the unit and attempt to enter command mode +++ I get a message back.
Does this indicate the unit is functioning and what and how should I be setting it so that I can get onto XCTU with it. I also don't seem to be able to choose an option here?
Thankyou in advance for any help you can give.