Home/Support/Support Forum/Using XBee 868LP with Raspberry Pi2 and Windows 10 IoT

Using XBee 868LP with Raspberry Pi2 and Windows 10 IoT

0 votes
Hi,
i would like to use the boards that comes with the XBee 868LP Development Kit with the Raspberry Pi2 and Windows 10 IoT.
Anyone has some experience on this configuration ?
If there is not any drive for the Windows 10 IOT based RPi2 can i use the pin an UART to USB convert like the ZigBee adapter kit that works with the Zigbee 802.15.4 ?
Thanks in advance
asked Dec 1, 2015 in Interface/Development Boards by delfo New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Digi uses an FTDI chip on the development board so I would check with FTDICHIP.com for your USB drivers.

If your Raspberry Pi2 has a 3V UART, then yes, you can just run jumper wires from it to the test points on the XBIB interface board.
answered Dec 2, 2015 by mvut Veteran of the Digi Community (11,300 points)
...