Home/Support/Support Forum/Xbee Rx Response and TX differents

Xbee Rx Response and TX differents

0 votes
Dear Friends,
In this opportunity despite of the "xbee pro s2b" (XBP24B7PIT) modules can communicate each other, the Rx value (0 - 1023) is different from the Tx analog value, additionally, the Rx value does not change although the Tx value changes.
Both modules are configured in API 2 (one as coordinator and the other as end device), have the same PAN ID, and so forth.
In order to reach this purpose I am using arduino boards UNO R3, xbee shields of DFRobot v1.4, and a Seeedstudio relay shield.
The main purpose of the sketch is to control a relay if the analog value is in between a definite range, but by the moment I am trying to visualize the Rx value in the monitor to confirm the that Tx and Rx will be the same.
Sincerely I appreciate very much your help.
Thanks in advance.
asked Nov 12, 2015 in ZigBee PRO Featureset (and legacy ZNet 2.5) by nicorodri New to the Community (4 points)

Please log in or register to answer this question.

2 Answers

0 votes
If I understand what you are saying, what is VREF connected to?
answered Nov 16, 2015 by mvut Veteran of the Digi Community (14,294 points)
0 votes
Hi mvut,
Thanks you very much. I am supplying 5v through arduino's usb connector to power xbee module and devices. Additionally, the sensor value is 0-1023 or 0-5v.
answered Nov 16, 2015 by nicorodri New to the Community (4 points)
edited Nov 16, 2015 by nicorodri
...