Home/Support/Support Forum/how to edit the function parameter in xctu 6.0.2 so that to set one xbee as coordinator AT

how to edit the function parameter in xctu 6.0.2 so that to set one xbee as coordinator AT

0 votes
Indeed to check the communication between two xbee s2 modules, i connected two xbee s2 modules on two different usb ports of my laptop and tried sending an ascii packet, but i am not aware of setting one xbee module as coordinator in xctu 6.0.2 version teminal. pls help out.
asked Oct 30, 2015 in RF Solutions and XBee by sandeep New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to use the Configuration screen or the Recovery function to change the firmware version.
answered Oct 30, 2015 by mvut Veteran of the Digi Community (11,298 points)
...