Home/Support/Support Forum/problem while interfacing Xbee S6B with router

problem while interfacing Xbee S6B with router

0 votes
HI
I have a communication problem with Xbee Wifi Module and the router. i am using AT command mode with given setting
TCP - enable
DHCP - enable
SSID- my router SSID (9 ASCII character which is mention in router setting)
network type-0 (IBSS joiner)
encription -1(WPA) (router has password)
baud rate -7 (115200)
destination address - router address

Is my setting correct?if no please share me the setting to connect router.

if WPA set on Xbee , how i set password of routers wifi on it?
asked Sep 11, 2015 in RF Solutions and XBee by micky2406 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Are you associated? The AI command will tell you if you have associated to the Router or not.

The destination IP address and port number should be the IP address of the device sending and receiving the data and not the IP address of the WIFI Router.
answered Sep 11, 2015 by mvut Veteran of the Digi Community (13,104 points)
...