Home/Support/Support Forum/wrporti crashes the debugger in rcm4000 when writing to portC, is there a fix for this?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

wrporti crashes the debugger in rcm4000 when writing to portC, is there a fix for this?

0 votes
asked Jun 24, 2015 in Rabbit Software by itworks New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
PC6 and PC7 are used for serial port A which is the port used by the debugger to communicate with the board. You need to be careful not to do anything to change these pins if you are using port C.

Regards,
Peter
answered Jun 28, 2015 by petermcs Veteran of the Digi Community (1,128 points)
...