Home/Support/Support Forum/Command in System-General-Atuo-Run commands
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Command in System-General-Atuo-Run commands

0 votes

This command is in the System-General-Autorun comands:
tcpperm ASY 0 4111 -l4111

is this necessary? I did not put it there so it must have been put there by the router.

Looking for some guidance here.

asked May 10, 2015 in Digi TransPort Cellular by jserink Community Contributor (74 points)

Please log in or register to answer this question.

2 Answers

0 votes
You have probably run the serial wizard.

This command means that you are allowing connections on port 4111 to connect to the serial port.
answered May 11, 2015 by NicholasWilson Veteran of the Digi Community (1,001 points)
0 votes
True, I did run the serial wizard....
But I deleted the command and the serial port still works in socket server mode.....that is, I can connect to

So what was the command actually doing if I can delete it and everything still works?

answered May 11, 2015 by jserink Community Contributor (74 points)