Home/Support/Support Forum/Is it possible to run HDLC bus at 2000kbps on a Rabbit 4000 ?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Is it possible to run HDLC bus at 2000kbps on a Rabbit 4000 ?

0 votes
Hallo, we are trying to Tx & Rx data to a sensor using HDLC on a Rabit4000 module. When using a synchronous bit rate of 500 kbps the transmit and receive works fine based on example code supplied. However, when trying the same at a higher rate: 2000 kbps (2Mbits/s), we experience an Abort sequence during transmission and no reception.

Therefore:

Are there any known upper limits for the synchronous bit rate of a rabbit4000?

Has anyone in the community used the rabbit4000 and its HDLC software with data rates of 2Mbit/s or higher with success ?

Thanks for any help.
kind regards
John
asked Apr 14, 2015 in Rabbit Software by bebbo New to the Community (0 points)

Please log in or register to answer this question.

...