Home/Support/Support Forum/Cannot reconfigure XBee module

Cannot reconfigure XBee module

+1 vote
Hi All,

I had a series 2 XBee module.I tried to configure it using XBee shield for Arduino. In USB mode, XCTU detected it and then i changed the firmware to Coordinator AT.Then i disconnected the Arduino board.

Now on connecting the board with shield again, the ASOC led on shield blinked continuously but XCTU could not detect the module.

I am a beginner in this area and hence i cannot understand why this is happening.
Any help is appreciated.

Thanks
asked Apr 13, 2015 in RF Solutions and XBee by rharsh New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
Are any XBee modules you connect to that USB board detectable? If not, you may have a driver issue or a faulty board.
answered Apr 21, 2015 by mvut Veteran of the Digi Community (11,298 points)
...