Home/Support/Support Forum/Explicit Transmit API frame (0x11) and no confirmation

Explicit Transmit API frame (0x11) and no confirmation

0 votes
Hi all,

I am sending Explicit Transmit API frame (0x11) frames using XCTU and the frame generator tool within it while my device is in API=2 mode. I am not getting any confirmation that the packets are being sent and when I sniff the network, there are no packets over the air.

Instead, over the air I see that my device is spamming the coordinator with data requests (63 88 D4 89 17 00 00 A2 B0 04 FF FF)

What are the conditions for (0x11) frame to be sent? Why am I getting absolutely no response? Note, I made sure to send to UART once every second so I'm still in API mode, and other commands (AT commands) give me responses.
asked Apr 7, 2015 in ZigBee Smart Energy Profile 1.1 by makorihi New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
The explicit frame is for sending ZDO or Zigbee Device Objects back and forth between applications and nodes. They must be properly formatted for you to see them come out the UART on a receiving module. They may also perform specific functions on the module depending on the ZDO request.
answered Apr 21, 2015 by mvut Veteran of the Digi Community (12,010 points)
0 votes
I recently had this problem and I think one problem is that you might not have the right security privileges you should read up here https://digi-se.appspot.com/edocs/certificate/certificate.html.

Let me know some more details if you want more specific help.
answered Jul 1, 2015 by RadiatorBen New to the Community (10 points)
...