Home/Support/Support Forum/Data sent in packets despite R0 (Packetization timeout) set to zero

Data sent in packets despite R0 (Packetization timeout) set to zero

0 votes
I have an Xbee Coordinator and a single End Device.

The end Device is getting six bytes of data to send every 15mS.

The baud rate is 115200.

At the Coordinator I get a large packet every 100ms.

I thought that setting the R0 Packetization timeout to zero was supposed to force transmission immediately?

Any ideas why it's still packeting up the data and sending every 100ms?
asked Mar 21, 2015 in RF Solutions and XBee by rich at home New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
On a router or coordinator it would. On an Zigbee End device the transmission time on when it sends data is based off of the Polling rate or PO command.
answered Mar 25, 2015 by mvut Veteran of the Digi Community (12,010 points)
...