Home/Support/Support Forum/Howto boot linux on ConnectCore 6
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Howto boot linux on ConnectCore 6

0 votes
Hello,

I am trying to boot a Linux kernel using this http://ftp1.digi.com/support/documentation/90001422_B.pdf tutorial on the ConnectCore 6 platform from a sdcard.

* u-boot binary image is copied onto the sdcard with the dd command as indicated.
* I have set a jumper has indicated at the end

I tried to use the provided files dey-image-minimal-ccmc6adpt.sdcard as well as the u-boot-ccimx6adpt.imx.
I also have tried to create a new image from the last u-boot sources and the 3.2 kernel.

In all these cases, the only result I have is one non-ascii character displayed through the serial terminal.

Standard androïd boot is OK when removing the jumper, but I cannot stop u-boot from booting when hitting a key as asked by u-boot.

Any help or tutorial to to boot a linux kernel from a SDCard on this platform is welcome.
asked Mar 11, 2015 in Linux by VRoqueta New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

+1 vote
Hello,
Have you changed the config file to boot from SDCard.
The paragraph below appears in the Linux BSP reference Manual.
http://ftp1.digi.com/support/documentation/90001424_B.pdf

If booting from a U-Boot in an external micro SD card, the U-Boot environment is stored at the micro
SD card, and the config file must be changed to point to that block device instead.
answered Mar 11, 2015 by Campbell Veteran of the Digi Community (552 points)
...