Home/Support/Support Forum/Error in read/write settings from my XBee PRO S1? (device recognized by XCTU)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Error in read/write settings from my XBee PRO S1? (device recognized by XCTU)

0 votes
I connect my XBee to the port, where COM is configured as:
9600 rate, 8 bits, no parity, 1 stop bit, flow control: none.

XCTU finds my XBee (during the discovery Request Action Box appears, but after device reset it disapears).

Whenever I click read/write radio settings or try to update the firmware, Request Action box appears, but device reset doesn´t close it.

I already checked COM settings as here: http://www.digi.com/support/kbase/kbaseresultdetl?id=3418

It is my begginning with XBee, I am not very experienced.
asked Feb 18, 2015 in USB Serial by alexandra11 New to the Community (0 points)

Please log in or register to answer this question.

...