Home/Support/Support Forum/Forwarding data to an end device through a Wall Router ZB

Forwarding data to an end device through a Wall Router ZB

0 votes
In our network we have an Xbee Gateway (formerly ConnectPort X2e ZB), Wall Routers (XR-Z14-CW1P1), and custom PCBs that implement Xbee SMT Modules (XB24CZ7PIS-004).

The custom PCBs are sleeping end devices that wake the Xbee Modules up (pin sleep) every 5s to check for any new data on their parent. If a module joins the coordinator (X2e) directly everything functions as expected, but if a module joins a Wall Router, messages do not appear to be buffered and delivered to the end device.

Initially I had issues with the child poll timeout, but I think I have that fixed and still experience the same issue. What I am setting on the Wall Router (beyond defaults) is:

JV = 0x1 ( since their behavior is annoying otherwise )
EE = 0x1 (
KY = 0x1234 ( Sets security for network )
SP = 0x3E8 ( 1000 x 10ms = 10s)

My understanding is that the sleep poll timeout should be (SP x SN x 10ms x 3) or 30s, and polling the NC AT register through XCTU, NC jumps back up one about 30s after an end device goes offline, so I think that is working correctly. However, the Wall Router still doesn't seem to be buffering messages.

To help further isolate my problem, I took an XBee SMT Module and inserted it into an XBIB breakout board. There I configured it through XCTU to set it up as a router with the same settings as I was applying to the Wall Router, and it appears to buffer messages and deliver them to the end device as expected. During these tests I was just using our "custom PCB" to drive the sleep wake line and monitoring serial activity coming from the SMT Module directly with a logic analyzer (to avoid potential external issues).

This leads me to believe my issue is with the Wall Router specifically, or the older through hole module at it's core that utilizes the older EM250 chipset (to my understanding). Is there something different I need to set for a parent of end devices because I'm working with a Wall Router/EM250 chipset vs a newer SMT Module/EM357?
asked Feb 16, 2015 in IEEE 802.15.4 by CHSH New to the Community (10 points)
edited Feb 17, 2015 by CHSH

Please log in or register to answer this question.

1 Answer

0 votes
What firmware version are you working with on the Wall Router?
answered Feb 25, 2015 by mvut Veteran of the Digi Community (11,302 points)
Wall Router: 22A7
X2e (Xbee Gateway): 3.2.7.10
   -X2e Xbee Module: 4043
SMT Module: 4053

I've been in touch with Digi support and they recreated my setup, only using a 4043 SMT module and were unable to reproduce the issue.  Our application requires the newer 4053 firmware, but I'm going to try downgrading to see if that fixes the child buffering issue (even if it breaks everything else).

What we were able to do as a short term fix was to double-sided tape X2es to their power plug and zip tie the power cord up neat to make it a "plug-in module" and configure those to function as simple routers.  This works and I've been slammed with another thousand smaller issues, but as soon as I can catch my breath I'll try downgrading the SMT firmware to test my theory with the wall routers.
...