Home/Support/Support Forum/Using the XCTU Next Gen software, how do I change the device type from "End Point" to "Coordinator"?

Using the XCTU Next Gen software, how do I change the device type from "End Point" to "Coordinator"?

0 votes
Working with Xbee 900HP S3B units, I noticed that my coordinator (AP1) says has the icon of End Point as the device type. How can I change this to "Coordinator".

I've set the DD value to 000B0000, which I think is correct, but has no effect on this icon.

Appreciate any help. Thanks.
asked Jan 19, 2015 in RF Solutions and XBee by mr2always New to the Community (0 points)
edited Jan 20, 2015 by mr2always

Please log in or register to answer this question.

1 Answer

0 votes
With the 900 HP Digi Mesh product, unless you are using sleep modes, there is no coordinator. Everything is an End device.
answered Jan 26, 2015 by mvut Veteran of the Digi Community (11,298 points)
...