Home/Support/Support Forum/XBEE S1 red led stays on

XBEE S1 red led stays on

0 votes
I have two XBEE S1s each plugged into a XBEE Adapater. Let's call them XBEE A and B. I have had these running perfectly for several days as I assembled all the components of the whole system - voice recognition, keypad etc. This has all been in bread board mode. Today I modified the wiring for the XBEE A part of the system to simplify it for inclusion into a hand held remote. When I finished the re-wiring and powered on, the red led on A comes on and stays on. B seems to behave as expected. When I trigger a transaction through A, I see B flash its red led as usual but the data isn't really transmitted. I'm using LCD displays in both parts of the system so I can see what's going on. I suspect I've done something to cause this but cannot figure it out. I connected it to XCTU and it's parameters appeared to be what I would expect. I tried re-setting XBEE A by shorting the RST pin to GND on the adapter but that did not change anything. I would very much appreciate any help in getting A back to normal.
asked Jan 8, 2015 in RF Solutions and XBee by denniscj7 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I think you need to tell us more on what your configuration is and what the Red led is suppose to be connected to.
answered Jan 14, 2015 by mvut Veteran of the Digi Community (11,642 points)
...