Home/Support/Support Forum/Changing XBee module from AT mode to API

Changing XBee module from AT mode to API

0 votes
Hi,
I recently Bought two XBee-ZB modules. one is cordinator and the other one end node. Both these modules are currently in AT mode. I want to change these modules to API mode. I am using X-CTU v6.1.0. How to perform these changes?
asked Dec 1, 2014 in IEEE 802.15.4 by Avinash Babu New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
Use the XBee Recovery function on the Tools menu to select the desired function set and version. Then write it to the module.
answered Dec 1, 2014 by mvut Veteran of the Digi Community (11,298 points)
selected Dec 2, 2014 by Avinash Babu
...