Home/Support/Support Forum/Continuous Transmitter

Continuous Transmitter

0 votes
I am using a single XBEE Pro HP as a 900 MHz RF source (I basically just need to broadcast the RF, I don't care about the actual content). When I connect with a terminal emulator, I get the bootloader page, but there is no application? I am assuming I need to put some code on there other than the bootloader? If so, is there a base project floating around somewhere that I can modify? I have installed the CodeWarrior project but this is for a school project and time is a bit short so I'm trying to get this up and running as fast as I can.

Thanks,
matt
asked Nov 18, 2014 in IEEE 802.15.4 by Goonior New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Matt, try going through some of the sample applications listed in the SDK that you should have installed as well. One of them may fit your needs.
answered Nov 18, 2014 by mvut Veteran of the Digi Community (14,249 points)
...