Home/Support/Support Forum/how can I alter the way which the Digi TS16 assembles serial data to avoid payload split between IP packets?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

how can I alter the way which the Digi TS16 assembles serial data to avoid payload split between IP packets?

0 votes
asked Oct 8, 2014 in Portserver TS by harryleebchydro New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
It is not possible to control the packet size with these units as they service the serial port data on a polling basis. You can lower or increase the polling rate using the optimize setting:

This can be configured using telnet or SSH to the connect to the unit, logging in as root and issuing the following command:

#> set config optimize=latency

This will increase the polling rate (putting higher load on the network).

#> set config optimize=throughput

This will decrease the polling rate.
answered Oct 13, 2014 by userid0 Veteran of the Digi Community (2,158 points)
...