Home/Support/Support Forum/Network Reset "NR" Command Invalid Parameter

Network Reset "NR" Command Invalid Parameter

0 votes
When attempting to perform a Network Reset on all nodes, the following frame is sent from the coordinator:
"7E 00 05 08 01 4E 52 31 25". The response that is received is: "7E 00 05 88 01 4E 52 03 D3" - Invalid Parameter. I tried both parameters (0 and 1) mentioned in the latest manual but still received Invalid Parameter. I thought it was the code I'm writing, but tried to send the NR command using the latest XCTU software and get the same results. Is there something that I'm missing?

Thanks
Rich
asked Sep 30, 2014 in ZigBee PRO Featureset (and legacy ZNet 2.5) by Storm017 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+2 votes
 
Best answer
The number 0 or 1 should be hex, not ascii. The frame for sending an NR = 1 should be:

7E 00 05 08 01 4E 52 01 55
answered Sep 30, 2014 by trooper2 Veteran of the Digi Community (589 points)
selected Sep 30, 2014 by Storm017
...