Home/Support/Support Forum/CTS hardware flow control

CTS hardware flow control

0 votes
hi guys, Thanks for your response ;)
my question is about the CTS pin in xbee 2 ZB; in my project i need to use it, but i don't know where to connect it with pic 18f4520 (which pin), any idea ^^.
asked Sep 24, 2014 in RF Solutions and XBee by yannis New to the Community (0 points)
edited Sep 24, 2014 by yannis

Please log in or register to answer this question.

1 Answer

0 votes
CTS is an output from the radio. It would need to be connected to an Input on the UART of the Pic.
answered Sep 24, 2014 by mvut Veteran of the Digi Community (12,542 points)
thanks for your answer;
i have just one UART in  my pic; so i will not able to use it ;)
juste for his use we d'ont need to configure any registre or interruption ?
...