Home/Support/Support Forum/i.MX53 module pin config (IO Mux)?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

i.MX53 module pin config (IO Mux)?

0 votes
I am using the i.MX53 with WCE, but need to config the pins on the module differently.

I have the Freescale IO Mux program, and can load, modify and save the "_Wi-i.MX53+JS_3.IoMuxDesign.rfull_with_jumpstart.xml"

How do use/transfer this file on the module, so the module gets the new configuration?
asked Aug 29, 2014 in Embedded Devices by handersen New to the Community (6 points)

Please log in or register to answer this question.

3 Answers

0 votes
i believe you have to configure BSP manualy - i do not think iomux intention is to do it for you automaticaly.
answered Sep 2, 2014 by LeonidM Veteran of the Digi Community (4,042 points)
How do I configure it manually, do you have a procedure?
Do you have a procedure how to configure the BSP manually?
0 votes
I don't know much about wince. google returns this:
https://community.freescale.com/thread/317223
http://geekswithblogs.net/BruceEitman/archive/2010/08/01/windows-ce-writing-an-application-to-test-gpio-pins.aspx
file:///C:/Downloads/BSP_iMX28_Ce6.0.201.pdf
answered Sep 8, 2014 by LeonidM Veteran of the Digi Community (4,042 points)
0 votes
Hello Handersen,
We have i.MX53 jumpstart kit. We plan to design our custom carrier board for the imx53 module. We'll use some additional GPIOs.

Do you have "Freescale IOMUX tool xml file" for this kit ?

Thanks
muguler
answered Sep 12, 2014 by gulermu New to the Community (2 points)
...