Home/Support/Support Forum/chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR"

chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR"

0 votes
When I program the XBee Pro by using XCTU, chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR" cause now I cannot get any serial communication with the XCTU, please help how I can get back the chip with the communication. Thanks!
asked Aug 19, 2014 in IEEE 802.15.4 by stephen New to the Community (0 points)
Have you found any solution? I have the same problem.

Please log in or register to answer this question.

1 Answer

0 votes
Try following the steps described at https://www.youtube.com/watch?v=fxOqQZD-oaM to reload your firmware files with.
answered Aug 19, 2014 by mvut Veteran of the Digi Community (11,298 points)
facing the same problem, but it doesn't work
...