Home/Support/Support Forum/How does Kitchen Network Utility "Load" Configuration get its information

How does Kitchen Network Utility "Load" Configuration get its information

0 votes
We have controller/routers over Xbee wireless connected to Connect X4 XBee Gateway to Ethernet and a supplied utility called Kitchen Network Utility that runs on a PC on the same Ethernet lan as the gateway. In Kitchen Network Utility is a " Load Configuration" used with the IP address of the Digi Gateway. When "Load Configuration" is pressed scanning is displayed and Mac Addresses of the controller/routers found on the Gateway/Coordinator are displayed one at a time. We are wondering what this "Load Configuration" uses to get its information as we are using it primarily to locate joined controllers.
asked Jun 17, 2014 in ConnectPort X3 by steveny New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I don't know what that software is using to achieve this as I have not seen the code you are referring to but I imagine that you could use the ND or Node Discovery command to collect the 64 bit addresses of the nodes within the network.
answered Jun 19, 2014 by mvut Veteran of the Digi Community (11,298 points)
...