Home/Support/Support Forum/Can I change the Xbee PRO S2 module Functionality mode, Pan id without using XCTU Software?

Can I change the Xbee PRO S2 module Functionality mode, Pan id without using XCTU Software?

0 votes
Here Xbee Pro S2 is interfaced with the MCU and i dont want to remove zigbee from the controller board, i want to set the zigbee in API mode and pan id through the commands sending from the MCU.
asked Jun 13, 2014 in RF Solutions and XBee by Suresh91439 New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
If the local XBee modules that is connected to the MCU is in API mode, then you could issue remote AT commands from that node to any other node within the network. Thus modifying the remote modules settings such as the PAN ID.
answered Jun 16, 2014 by mvut Veteran of the Digi Community (12,544 points)
...