Home/Support/Support Forum/migrating from dynamic c 7.21 to 9.62. cannot find stdbios.c.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

migrating from dynamic c 7.21 to 9.62. cannot find stdbios.c.

0 votes
migrating from dynamic c 7.21 to 9.62.

Getting error: cannot find stdbios.c.

stdbios.c is located at ...\LIB\BIOSLIB\.

Not sure if I should move the file or change the code or do something else??

The RabbitBios.lib file is much smaller in rev 9.62. Where did all of that content go?
asked Jun 9, 2014 in Rabbit Software by Kingfisher New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Are you getting this error when running standard samples in Dynamic C?
answered Jun 9, 2014 by MargaretK Veteran of the Digi Community (545 points)
Yes, I do get this error with standard samples.  The error occurs when the bios is reset (control - Y).
0 votes
Hello, If you installed Dynamic C 9.62 successfully in your development PC, the STDBIOS.C file should be under below path,
C:\DCRABBIT_9.62\Lib\BIOSLIB

If the file is not there, I suspect that, Dynamic C did not install properly. If this is the case , uninstall Dynamic C 9.62 from the "programs and features" then install once again.

Thanks.
answered Jun 10, 2014 by cpigilam Veteran of the Digi Community (655 points)
...