Home/Support/Support Forum/Digi One SP won't connect after firmware upgrade.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Digi One SP won't connect after firmware upgrade.

0 votes
I upgraded the firmware on one of my One SPs without upgrading the post first and now when I power up the unit the power led flashes four times then goes off and I cannot connect through either port. Resetting the unit results in the usual 1-5-1 blink pattern but upon resealing the reset switch the power led flashes four times and then goes off. Does anyone have any suggestions for recovering this unit? I have tried the recovery method when the blink patter is 1-9-1 and I get no response.
asked May 26, 2014 in Other/Legacy by ddavidadams New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You might want to take a look at the link below, on
How to Recover A Digi One SP or Digi One IA

http://www.digi.com/support/kbase/kbaseresultdetl?id=893
answered Jun 6, 2014 by Campbell Veteran of the Digi Community (552 points)
...