Home/Support/Support Forum/XBee Pro 900HP, "route not found", status delivery =25

XBee Pro 900HP, "route not found", status delivery =25

0 votes
I have two XBee modules configured with API=1. One of them is the Coordinator (CE=1), another one is Router (CE=0).

The Coordinator is plugged on Digi USB development board, and controlled by X-CTU soft.
Config Coordinator:
NO: 5; TO: C0 (digimesh); SM: 0 (Normal)

The end device/router, is driven by a microcontroller.

The transmission from End/Rouder to Coordinator, is OK, and the Coordinator send a "successful transmission status" but, when I tray to send a API "Transmit Request" frame to End/router device:

7E [00 0F] [10] [01] [00 13 A2 00 40 A5 06 BF] [FF FE] [00] [00] [55] [3D]

[00 13 A2 00 40 A5 06 BF] : MAC address end/router
[55] : data byte.)

the end/router device send a message "Route not Found", status delivery=25, etc. and, of course, the packet is discarded on the end/router device.

Any suggestion about this issue?

asked May 12, 2014 in DigiMesh Proprietary Mesh Networking by vasama New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

+1 vote
Best answer
What happens if you use a directed broadcast instead of a Mesh? (TO80 instead of C9)
answered May 15, 2014 by mvut Veteran of the Digi Community (12,544 points)
selected May 26, 2014 by vasama
Hello mvut,
Does you answer mean that if i set the TO to 0x80, my XBee-Pro 900 XSC S3B will act as a router ? and if so, will this help in extending my xbee range?
Thanks in advance
Yes, the default function of the 900 HP module and its related firmware is for all nodes to act as Routers.