Home/Support/Support Forum/Wrong FrameID and AT command name in failed remote AT command response

Wrong FrameID and AT command name in failed remote AT command response

0 votes
I have been trying to send remote AT commands using the API mode and XBee PRO with the latest Digimesh firmware and some previous versions (8062 and 8067).
While requested nodes are switched on and reachables, the remote AT command responses work like a charm. However, if the node is not reachable, the AT command error does not work properly. Although the error code is received indicating TX error (0x04), both Frame Id and AT command name in responses do not match with the requested parameters. Furthermore, these values change with every request (even if it is the same).

Is this proper behaviour documented elsewhere or it is just a bug in the Digimehs firmware? At following you can find an example of this weird behaviour (extracted from X-CTU program).

Frame sent: <frame_payload>7E000F17270013A20040078BC0FFFE006264B7</frame_payload>

Frame received: <frame_payload>7E000F97E70013A20040078BC0FFFE143F04E6</frame_payload>

Thanks in advance.
asked Apr 22, 2014 in DigiMesh Proprietary Mesh Networking by Kirsath New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
The API frame you received back indicates:

04 - Remote Command Transmission Failed which is what I would expect if the module is not in the network.
answered Apr 30, 2014 by mvut Veteran of the Digi Community (12,786 points)
Yes, we have already noticed that. However, even if the node is neither reachable nor in the network, the Frame Id and the AT command name should match with the request (and it does not).
Hello,
I have XBee 865/868 LP module, and i want to send AT command to XBee router through XBee coordinator and it is in API mode and XBee  router in AT mode, when router in normal mode means that router not in sleep mode then coordinator send remote AT command and router are receive it but when i configure router in Synchronous cyclic sleep mode with 5 sec wake up and 16 sec sleep but router can not receive AT command but i got TX error in Remote command response.

i have continues send remote AT command to router so when router is wake up then it receive command and give response without any error.  But i have not get positive response but i got TX error so please give me solution about my problem.
...