Home/Support/Support Forum/I like to have coonfigurar the XBEE API response to a frame sent

I like to have coonfigurar the XBEE API response to a frame sent

0 votes
Hello. I am working in API mode, the coordinator (configured as API coordinator) send the frame 7e 00 04 08 52 44 42 1F to Xbee end device, but the xbee end device API set as I do not get a response.
 as I coonfigurar the XBEE to be answered?
related to an answer for: how I can measure the XBee signal RSSI ?
asked Feb 14, 2014 in RF Solutions and XBee by maryxb New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
If you meant to send a remote AT command to change a value on your end device from the coordinator, you want to use the frame type 0x17. The frame 0x08 is a local AT command and will affect the local node you are connected to the UART of.
answered May 8, 2014 by mvut Veteran of the Digi Community (12,351 points)
...