Home/Support/Support Forum/xbee wi-fi hyper terminal

xbee wi-fi hyper terminal

0 votes
The Xbee Wi-Fi device I recently purchased for prototyping will not respond to TCP connection attempts.

The device is connected to a FTDI cable through an interface board I had made for the Xbee Pro. The Xbee Wi-Fi has the default factory settings except that it is configured to TCP under the IP configuration. The firmware version is 2021.

The software I am using for the TCP connection is hyper terminal running on an XP machine. I can see the device from the router and the IP and Sub net displayed in XCTU ver 6.1.0 are all showing as expected. The device will respond to pings.

Also, when the XCTU terminal window is connected and I try to use a web browser (Firefox,) to connect to the device I see no actions taking place in the terminal window.

I have also tried to make connections using a well tested VB.Net package I wrote some years ago without success.

Any tips or documents that might help? Thank you.
asked Jan 13, 2014 in Miscellaneous Hardware and Software by MaasRowe Tech New to the Community (0 points)
Have I placed this under the wrong category?  The pull down selections didn't have a clear category for the Wi-Fi unit.

Please log in or register to answer this question.

1 Answer

0 votes
What is the Association indicator report? Have you tried using UDP as the protocol and Puddy to view the data being sent?
answered May 30, 2014 by mvut Veteran of the Digi Community (11,300 points)
...