Home/Support/Support Forum/Issue with Router AT and Coordinator API

Issue with Router AT and Coordinator API

0 votes
Hello,
I am trying to make my two xbee working with this configuration:

Two XBP24BZ7 that one is going to be the coordinator API mode and then the other one Router AT that sends the status of the Digital pin 4 ( push button ).

I have uploaded the Coordinator with the latest firmware and PAN ID 17, the rest is default values.
I have uplodaded the Router AT with the latest firmware and PAN ID 17, JV True , Pin 4 Digital input and IR 3e8.

My Coordinator always blinks, and from the arduino via serial, I can't get anything ( 9600 baudrate ).

The Router seems to dont send anything because the TX and RX leds are doing nothing ( or I have to look at other leds? ).


Can someone help me in this problem? Thanks!
asked Dec 25, 2013 in ZigBee PRO Featureset (and legacy ZNet 2.5) by max246 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I have the same issue but using ADO0 at the router...I see no answers to your post, but did you manage to solve it?
answered Mar 27, 2014 by lolbeat New to the Community (1 point)
I discovred that on the router or coordinator there was a ID sending or ID receiving that different.
I was setting everything to ZERO so I would send to the anyone.

After I changed the variable I had the  data coming
...