Home/Support/Support Forum/Difference between slave ports and auxilliary I/O bus?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Difference between slave ports and auxilliary I/O bus?

0 votes
asked Nov 19, 2013 in Rabbit Software by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
The slave port is a parallel communication port that can be used to communicate with an
external master device. The slave port consists of three data input and data output registers,
and a status register.

The Rabbit 4000 can enable a separate auxiliary I/O bus for external devices to keep bus
loading on the memory bus at an acceptable level. This bus consists of eight data lines on
Parallel Port A and up to eight address lines on Parallel Port B. This functionality is mutually
exclusive with the slave port and regular parallel I/O on Parallel Ports A and B.
When enabled, the address lines of the auxiliary I/O bus hold their value until a new value
is written to them. The data lines return to a tristate mode after each transaction.
answered Jan 20, 2014 by MargaretK Veteran of the Digi Community (545 points)
...