Home/Support/Support Forum/Why must I Cycle Power on anywhereUSB14 for it to be discovered after a server power cycle?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Why must I Cycle Power on anywhereUSB14 for it to be discovered after a server power cycle?

0 votes
Scenario:
1. My server and AnywhereUSB 14 are both powered down.
2. The sever and AnywhereUSB are powered up at same time.
3. The Server(a vmware ESX host) takes > 10 minutes to fully startup and the virtual machines up and running.
4. The virtual machines do not reconize the AnywhereUSB
5. I have to cycle the power on the AnywhereUSB, which means pulling both power plugs since the unit doesn't have a power switch, to get the virtual machines to recognize(discover) the AnywhereUSB and everything works great.

Question:
Is the AnywhereUSB timing out somehow because the server takes so long?
The AnywhereUSB has a fixed IP.
TAny advice would be greatly appreciated.
asked Nov 11, 2013 in USB Serial by dcrouch New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If you receive the error message -" no concentrators found"
refer to the KBase

http://www.digi.com/support/kbase/kbaseresultdetl?id=1026

also refer to the below KBase articles as well

http://www.digi.com/support/kbase/kbaseresultdetl?id=1031

http://www.digi.com/support/kbase/kbaseresultdetl?id=1061
answered Nov 26, 2013 by sans0909 Veteran of the Digi Community (280 points)
...