Home/Support/Support Forum/Can we copy a data from memory to a port and then read it in RCM4000?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Can we copy a data from memory to a port and then read it in RCM4000?

0 votes
asked Sep 26, 2013 in Rabbit by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Your question is not very clear. Please rephrase it. Are you talking about a serial port or a parallel port or do you want to send something via a TCP connection?
answered Sep 30, 2013 by trooper2 Veteran of the Digi Community (589 points)
It is about parallel ports.
You should be able to do it programmatically.  Are you looking to store 1's and 0's into memory and send them out a parallel port?  If so, you should be able to do it with C code.
I want to send the data from a memory location inside RCM4000 to the parallel ports.How can I program so?
I want to send the data from a memory location inside RCM4000 to the parallel ports.
...