Home/Support/Support Forum/I can't connect to Digi Connect ME
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

I can't connect to Digi Connect ME

0 votes
I need to work with a module "digi connect me", but I can not connect to it

I have connected the pins of the module:

7 - TX
8- RX
14 - Reset -> to vcc (3,3V)
15 - VCC -> to vcc 3,3V
16 - GND
20 - SWRST -> to vcc (3,3V)

When I connect the power to the module, the module serial port sends this:

.NET OS Version 6.x.2
Copyright (c) 1997-2007, Digi International, Inc.
.
.PLATFORM: connectme
.APPLICATION: Ram-based FTP Server Application
.
.NETWORK INTERFACE PARAMETERS:
. The board will obtain IP configuration parameters from the network.
.HARDWARE PARAMETERS:
. Serial channels will use a baud rate of 9600
. This board's serial number is N99999999
. This board's Ethernet MAC Address is 00:40:9D:46:0B:72
. After board is reset, start-up code will wait 5 seconds
Default duplex setting for Ethernet connection: default
.
.Press any key in 5 seconds to change these settings.

IAM - Got DHCP IPv4 address 192.168.1.50 on interface eth0
.IAM - Got AUTOIP IPv4 address 169.254.68.49 on interface eth0:0
.Network IP configured.
.RAM based FTP Server ready.

The ethernet port of the module is connected to router with DCHP enabled. My PC is connected to the same router. The IP of the PC is 192.168.1.48. The firewall and the antivirus of the PC it's off.

In the terminal console I sent a ping to 192.168.1.50 and this responds ok

The yellow LED is connected fixed and the green LED is off but this is ON when i send a ping to module and turn off later.

I go to web browser to direcction 192.168.1.50 but this don't respond. Why?

In terminal console, I send telnet 192.168.1.50:23 and telnet 192.168.1.50:4401 and telnet 192.168.1.50:80 but don't respond anything.
asked Jul 1, 2013 in NET+OS by jnavarro New to the Community (0 points)
recategorized Sep 19, 2013 by tuxembb

Please log in or register to answer this question.

2 Answers

0 votes
Assuming I remember correctly, the default shipping application supports ftp but not http. You should be able to ftp into the device using username user and password password. You'd need to ftp an application (image.bin) into the device. An application that included http (a web server). If you do so you are advised to create an application that includes both ftp and http.
answered Jul 1, 2013 by dakotas_dad Veteran of the Digi Community (694 points)
0 votes
Hello, in what program did you see this lines? Was your device found by the Digi Device Discovery Tool? I'm having the same problem.
answered Jul 30, 2013 by MarcosBontempo New to the Community (1 point)
Ok, so by virtue of this output we know that the module is a -C, meaning it is associated with a NET+OS development environment.

What do you mean by the statement "Hello, in what program did you see this lines?"....

There is a good chance you are using the discovery tool that onliy works with the -S module (plug-and-play). The discovery tool for the -C module (associated with the NET+OS development environment is shipped with NET+OS. Thus besides doing FTP, you will not be able to do much with this module without the NET+OS development kit.
...