Home/Support/Support Forum/Help Interfacing XBP24-ZB to Picaxe MCU

Help Interfacing XBP24-ZB to Picaxe MCU

0 votes
Hi,

I've been searching for days about how I should this..

Basically, I want a Picaxe microcontroller (5v 40X2) to send serial data to another Picaxe through XBee Pro.

I have configured one the modules as Co-ordinator AT, and the other as End device AT.

When interfaced to PC throgh USB adapters, I can send text from the X-CTU's terminal form the coordinator to the End device successfully,
But when it comes to Picaxe interfacing, I can't get it working.

I have connected the Picaxe's serial OUT to the XBee D-IN through a voltage divider setup, and the XBee's D-Out to the Picaxe's serial IN directly.

Baud rate settigns are 9600-8-N-1 for all devices..


The BASIC code for the picaxe is this:
Code:
serout C.6, T9600_32, ("LED_ON",#b0)
asked Mar 19, 2011 in ZigBee PRO Featureset (and legacy ZNet 2.5) by robertgrech91_at_gmail.com New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Hi,
If you still facing problem in the interfacing, then you can check Schematic for XBIB-R-Dev board on www.digi.com for your reference.
answered Mar 22, 2011 by shahrj1988 Veteran of the Digi Community (263 points)
0 votes
Get the PICAXE code working without the XBees first.
answered Apr 7, 2011 by waltr Community Contributor (85 points)
...