Home/Support/Support Forum/GPIO Serial Mux
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

GPIO Serial Mux

0 votes
I am trying to select the GPIO function that is mux'ed with Serial port B on this ConnectCore Wi-9C board. I have changed in #define BSP_GPIO_MUX_SERIAL_B to BSP_GPIO_MUX_INTERNAL_USE only in the gpio.h file. I have also tried disabling the serial driver for serial port b in the bsp.h file. When I try toggling this port there is no effect. I have been successful doing this with GPIO pins that are not multiplexed. This is all with net os 7.0. Any help would be greatly appreciated.

asked Apr 3, 2007 in NET+OS by abettino New to the Community (0 points)
recategorized Jun 17, 2013 by mcarver

Please log in or register to answer this question.

1 Answer

0 votes
Make sure you're using the NAconfigureGPIOpin to configure the GPIO pin (checking the return value), and then use NAgetGPIOpin and NAsetGPIOpin to change the GPIO values.

If you really want to bypass the APIyou can go directly to the appropriate registers, see the 9360 hardware reference guide for details.
answered May 16, 2007 by charliek Veteran of the Digi Community (408 points)