Home/Support/Support Forum/RCI commands not working
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

RCI commands not working

0 votes
Hello,

I have one Digi Connect ME with a PIC18F connected to it by serial communication.

I want to configure it by RCI commands, but DIGI doesn't listen to me.....

I have:

1-DSR at 3.3v
2-Serial baudrate at 9600bps.
3-I have enabled RCI serial commands.
4- I send characters serial trought UART PIC:


<rci_request version="1.1">
<set_factory_default/>
</rci_request>


Questions:

1-I have to put "/n" between commands?
2-I have to change "<" and ">" to “&amp;lt” and “&amp;gt” ?


Please, anyone that TEST with PIC18F <---> RCI comands??


Thanks lot!

Best Regards
asked Jun 17, 2012 in Plug N' Play by kotiko New to the Community (1 point)
recategorized Dec 4, 2013 by tuxembb

Please log in or register to answer this question.

2 Answers

0 votes
Hello,

Digi documentation is very BAD. DSR signal is activated by 0V, it's negative logical. In digi's documentation says that the DSR have to be raised to activeted DSR.

Now I recive the welcome message "<rci_request version="1.1">...."

But I send:

<rci_request version="1.1"> + 0x0d
<set_factory_default/> + 0x0d
</rci_request> + 0x0d

and connect ME doens't responds. I think that the problem is that I have all the serial pins with pull-down.

Best regards, Joan
answered Jun 21, 2012 by kotiko New to the Community (1 point)
0 votes
Hello Joan,

Which version of Connect ME are you having?
Can you provde me the P/N? Is this a NDS device? If so you need to configure serial ports to listen to RCI Commands.
answered Jun 27, 2012 by bobthomas13 Seasoned Professional (182 points)
...