Home/Support/Support Forum/RCI over serial not working
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

RCI over serial not working

0 votes
Hello,

I have one Digi Connect ME with a PIC18F connected to it by serial communication.

I want to configure it by RCI commands, but DIGI doesn't listen to me.....

I have:

1-DSR at 3.3v
2-Serial baudrate at 9600bps.
3- I send characters serial trought UART PIC:


<rci_request version="1.1">
<set_factory_default/>
</rci_request>


Questions:

1-I have to put "/n" between commands?
2-I have to change "<" and ">" to “&amp;lt” and “&amp;gt” ?


Please, anyone that TEST with PIC18F <---> RCI comands??


Thanks lot!

Best Regards
asked Jun 17, 2012 in Plug N' Play by kotiko New to the Community (1 point)
recategorized Nov 26, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
I have 2 thoughts on your problem.

It might be the change in DSR from 0 to 3.3V that triggers the RCI to start listening. If I understand correctly when the RCI is ready to handle commands, it will send out <rci_request version="1.1"></rci_request>.

Second, try <set_factory_default action="factory"/>

You should not have to put any newline characters or make other changes you mentioned to the RCI.
answered Jul 4, 2012 by kurte New to the Community (29 points)
...